How much rope do I need? You want enough rope to form all the bends of the knot, plus enough trailing out afterwards so that the knot won't come undone from a little slippage. How much is enough? Depends on how thick the rope is, and how slippery it is, and how big and complex the knot is. Get in the habit of both tying and untying knots. If you realize half-way through that you don't have enough rope to finish a knot, say to yourself "No worries!" and untie the knot. Start further up the working end, and go at it again.

2torial #0540: Learn2 Tie Basic Knots (Continued) Knot 6: Lets go bowline Sometimes you need to make a loop at the end of a rope that'll stay a loop. The bowline (pronounced BO - lin) is a critical knot used to make a loop that's secure and will stay open for as long as you need it. An old mariner's saying goes, "I could make the devil himself a good sailor if he could learn a bowline." Step 1: Hold it Hold the working end (the longer end) of a rope in your nondominant hand. The working end should trail up and away from you. Step 2: Loop it   Make a loop by passing the free end over the working end. For purposes that'll soon be clear, call this loop "the hole." Hold the hole with your nondominant hand at the point where the two ends cross over. Note: When you make this loop, it's critical that the free end pass on top of the working end. It's also a good idea to make it relatively small, because in the bowline there's a second, larger loop that should be easy to distinguish. Step 3: Thread it Move the free end under the hole, and pass the free end up through the hole. (Leave enough rope hanging down on this free end. Later, it'll form the second, larger loop.) Step 4: Wrap it Pass the free end over the working end, then around behind it, and then back down the hole again. Be sure you pass the free end through the small loop of the knot and not the second, larger loop you're creating. Step 5: Tighten it Hold the free end and the side of the larger loop together in one hand. Hold the working end in your other hand. Pull gently on the working end until the knot is snug. Then grab the loop with one hand, the working end with the other, and pull tight. Step 6: Remember it! Here's a clever way to remember the bowline: imagine a pastoral woodland scene. The free end is a rabbit; the working end is a tree with a rabbit hole at the bottom of it. Say to your self, "The rabbit comes out of the hole, goes around the tree and back down the hole again." Knot 7