|
2torial #0438:
Learn2 Build a
Campfire
Satisfy that burning desire...
There are two kinds of campfires in this world:
the campfire that you build to enjoy, and the
campfire that you build to survive. If you're in
the latter situation, your best bet is to carry any
one of a number of widely available fire "helpers."
Often based on either magnesium shavings or an
inflammable paste, these burn at extremely high
temperatures, which can ignite wet material in an
emergency. The techniques described below are still
valid... but under really wet conditions, don't
depend on natural materials.
The following is a guide to building a fire
without any such "helper" materials. If survival
isn't the issue, all you need is a source of fire,
a bit of patience and some consideration for your
environment.
Most importantly, remember that fire is
destructive if not controlled. Check that fires are
permitted in your campsite, and keep water handy.
Also, be aware that deforestation is a problem
in many areas. Use as little gathered wood as
possible, and consider bringing in your own
firewood if you're not backpacking.
That being said, it's guaranteed that you'll
deeply impress your companions if you can build a
one-match fire. You'll succeed by following several
strategies. Choose the driest, least green
materials available, build the fire starting with
small pieces and moving to large, carefully control
the ventilation, and politely ignore any misguided
suggestions from casual observers.
Prepare the site
Fire will ignite any flammable materials
underneath it. Building yours on top of a metal
firepan is the surest way to control it. In any
case, you'll minimize the risk by clearing an area
at least three feet wide of debris and children. If
no established firepit is available get down to
bare earth, or to rock if you can, and put a ring
of stones around it for aesthetics and extra
protection (kids love hunting for good rocks).
Consider the wind, and attempt to find an area
that's shielded from the strongest gusts. Consider
also the possibility of rain, and see if there's a
sheltered nook around. But be careful of flammable
branches and tree trunks.
Gather the fuel for the fire
You need three types of materials to build a
fire: small stuff (tinder and kindling),
medium stuff (half-inch diameter sticks and
one-inch diameter sticks), and large stuff
(large chunks of wood).
Small stuff:
- Tinder is very lightweight and dry
material that will burn quickly and ignite the
heavier materials. Examples of tinder are pine
needles, grass, leaves, paper, and thin tree
bark. In areas where birch bark is available,
check around for fallen logs for this excellent
tinder fuel. Don't strip any birch bark off
an upright tree, even if it looks dead. This
can kill a tree by exposing it disease, insects,
and dehydration.
- Kindling: A large supply of tinder
and kindling is the foundation of a good fire.
Search around the base of shrubs and small trees
for dead branches. Don't break any piece of
wood off an upright tree, even if it looks
dead. It's bad for the tree and the wood
won't burn well.
Medium stuff:
- Half-inch and one-inch diameter
sticks: These will be used to build
fire-establishing structures. Search under
larger shrubs and trees for the medium stuff.
The same guidelines for gathering kindling apply
here: leave the upright trees alone. Break
longer branches into six- or eight-inch pieces
with this technique: rest one end of the
stick at a 45 degree angle to the ground. Grasp
the stick about 16 inches from the end on the
ground, or simply rest the top end against a
large tree. Stand with the ground end of the
stick just outside one of your feet. Lift that
foot and stomp down on the branch. It should
snap with a satisfying sound. If it doesn't, try
again, perhaps with your hand a little higher on
the stick, or kick a little lower towards the
ground.
Large stuff:
- Large chunks of wood: If you're in an
established campsite, large chunks of wood will
be available for purchase. Aside from the
convenience of this option, it also conserves
the limited and highly used resources of
established campsites. If you're far away from
civilization and established campsites, look
around for fallen trees. If you have an axe,
split the wood into chunks about the size of
your arm or a little larger. Avoid any mushy
wood--this has rotted and won't burn well.
Place the tinder and build the
teepee
Put a handful of tinder in a compact pile (a
little bigger than a golf ball) on the ground.
This will be the heart of two simple structures: a
"log cabin" built directly over a "tepee." Both of
these surround the tinder.
Using the kindling, build a small tepee
around the tinder. Gaps will form naturally as
you place the twigs. That's okay, you'll be
dropping a match through one of those gaps.
Build the cabin
Now you'll take up the dry sticks and branches
that are about 1/2" diameter. Build a cabin, with
no roof, around the teepee:
- Place two sticks on the ground parallel
to each other and around the teepee. Form a
square by placing another two sticks on top of
the first two sticks. The sticks will overlap at
the corners (see picture).
- Then place four more sticks directly on
top of the first four. Again, the corners
should overlap. But this time make the square a
little smaller.
- Repeat this a few times, until the
teepee is loosely surrounded.
- Put a loose roof on top. Remember to
leave several half-inch gaps in it that match
the gaps in the walls. With this design, the
flame will be able to "breathe." You should
still be able drop a match in between the gaps.
Place the larger stuff
In this step you'll create a "chimney" effect by
the careful placement of one-inch diameter sticks
and large chunks. This will give the young fire a
good flow of air, which will get it burning well.
- Put one of those good-sized chunks of
wood right next to the cabin. Put another
one on the other side of the cabin.
- If you have one chunk of wood, lean
some one-inch diameter sticks against the chunk
and over the cabin. If you have two chunks, rest
the sticks on the two chunks, suspended over the
cabin.
Step back and survey the area. Make sure
that there are no live, overhanging branches that
are in danger of being set on fire.
Spark it up
Wait for the breeze to die down, if there is
one. Shield the area from the wind with your body
if you have to. Assuming you've collected solid
(not rotted), dry materials, you should be able to
light the fire with a single match.
Kneel down and strike a match. Shielding
it from the wind, drop it through the gaps onto the
tinder inside the tepee. If this is not possible,
sneak the match through the bottom side of the
cabin. Once the larger sticks are burning, you can
let the other folks gradually and gently
place larger material on. To encourage a struggling
fire, kneel down beside it. Inhale deeply, and blow
gently and steadily along the ground and into the
base of the fire.
Extinguish the fire
When you're ready to sleep or leave the
campsite, make sure that fire is fully
extinguished. Use generous amounts of water or
whatever other liquid is available (hint, hint). If
you're in the backcountry and you're far from a
water source, throw many shovelfuls of dirt on the
fire. Avoid using moist, rich-looking dirt with
decomposed leaves and wood--this material is
inflammable. Scrape up a bit of ground with a stick
or trowel, checking for smouldering bits of
material under the dead coals.
Put your hand on the surrounding ground to feel
for heat. Believe it or not, half-extinguished
campfires can smoulder and continue burning under
the surface, especially if years of compressed
debris are present.
-end-

Learn More!
|